Sponsored

Recent content by Papaw2018

  1. King Ranch Club; Post Them Photos

    I must say… awesome looking KR: we share the same interests (attached)
  2. Front Diff Pinion Bearing Failure

    I’m not sure- it’s super quiet though 👍🏻
  3. Front Diff Pinion Bearing Failure

    UPDATE: New Front Diff. Replacement. They did not perform a Rebuild as quoted. All under warranty 🙌🏻👍🏻👍🏻
  4. Front Diff Pinion Bearing Failure

    Just wondering here🤔🤔🤔🤔
  5. Front Diff Pinion Bearing Failure

    I’m adding my KR to this perpetual saga. 42k on my 2022 KR 5.0 and front diff is getting rebuilt this week. Vibration in floorboard and pedal with noise up front was noticeable at 39/40mph-+. All fluids had been replaced many months ago and then all the sudden > low noisy growl Up front. One...
  6. Need Help/Advise

    This sounds like my nightmare- Went in for a filter/fluid change and afterwards blew it through the vent- Went back ( our fault) it was overfilled . Then back again a week later for bad gasket ….then overfilled again. They said it checked good and we took a little more out and you’re good to...
  7. Anyone using Nitto Terra Grappler G3 tires?

    Were the Toyo AT3 quiet on the road??
  8. Anyone using Nitto Terra Grappler G3 tires?

    Great. Thank you. Nice setup/ride
  9. Anyone using Nitto Terra Grappler G3 tires?

    Could you post a few more photos? I am thinking of this same tire and size for my 2022 KR. Thanks
  10. Anyone using Nitto Terra Grappler G3 tires?

    Could you provide a few more photos as I am thinking of this exact tire and size for my 2022 KR.
  11. Cup holder light installation / media bin light / glove box light / ambient lighting change

    Mine was broken too however I just ordered another one as they had a lot in stock in 2022 but as John has stated: Superglue will fix your problem because it kept my broken one and Superglued it together.
  12. Stock 2024 XLT with Falken Wildpeak AT4 275/60R20

    Nice, No level ?? I’m looking to do a 1.5 Motofab to fit LT275/65r20
  13. Cup holder light installation / media bin light / glove box light / ambient lighting change

    I see, you need more than just a wiring harness. You need the lighting filaments as well.
  14. Cup holder light installation / media bin light / glove box light / ambient lighting change

    John should be able to assist you @JHForman812
  15. Cup holder light installation / media bin light / glove box light / ambient lighting change

    And tab sheet 81 and 85 may give you some more visible insight…..




Top