Search results

I must say… awesome looking KR: we share the same interests (attached)

I’m not sure- it’s super quiet though 👍🏻

UPDATE: New Front Diff. Replacement. They did not perform a Rebuild as quoted. All under warranty 🙌🏻👍🏻👍🏻

Just wondering here🤔🤔🤔🤔

I’m adding my KR to this perpetual saga. 42k on my 2022 KR 5.0 and front diff is getting rebuilt this week. Vibration in floorboard and pedal with noise up front was noticeable at 39/40mph-+. All fluids had been replaced many months ago and then all the sudden > low noisy growl Up front. One...

This sounds like my nightmare- Went in for a filter/fluid change and afterwards blew it through the vent- Went back ( our fault) it was overfilled . Then back again a week later for bad gasket ….then overfilled again. They said it checked good and we took a little more out and you’re good to...

Were the Toyo AT3 quiet on the road??

Great. Thank you. Nice setup/ride

Could you post a few more photos? I am thinking of this same tire and size for my 2022 KR. Thanks

Could you provide a few more photos as I am thinking of this exact tire and size for my 2022 KR.

Mine was broken too however I just ordered another one as they had a lot in stock in 2022 but as John has stated: Superglue will fix your problem because it kept my broken one and Superglued it together.

Nice, No level ?? I’m looking to do a 1.5 Motofab to fit LT275/65r20

I see, you need more than just a wiring harness. You need the lighting filaments as well.

John should be able to assist you @JHForman812

And tab sheet 81 and 85 may give you some more visible insight…..

You may also have to slide the whole console back in which is pretty easy , just remove the two front screws at the front console after removing the side trim pieces and two back side screws (right behind the front seat sliderails). Then slide the whole console back to give a good visible on...

Look at tab sheet 101, where the subscriber has removed the center cup holder bezel, there you can see one of the black retaining screws to remove the center media slider and phone charger. As you know the center cup holder bezel lifts straight up - I believe you may need to remove these...

VERY Nice King Ranch and those colors _AWESOME_ Could you post a few close up photos of your Fx4 decal..."I'm completely OVER the gaudy "Red' FX on my 22 Star White KR and seriously thinking of ordering your decal color(from the dealer I guess). Again, I'm hating the "Red" FX and wanting...

Thanks ….KR looks awesome. Nice Ride!!!

Thanks, You running stock tire size …..275/60 20’s