Recent content by Moe7

This. Replacing the actual shock was easy by dropping the LCA, but I had a hell of a time getting the alignment to something driveable afterwards.

I'd bet on a GPF, it's been rumored for a while.

10 replies, 8 different recommendations :ROFLMAO:

Haven't used it on the truck, but I picked this up a few years back for our other cars - Optimum Opti-Bond Tire Gel (https://a.co/d/7vfmxUT) If I remember right, I was looking for a more matte look and this is where my research got me.

The hitch is fine with the play. But to get rid of the sound you can use something like this: https://www.amazon.com/dp/B07V57Z6NP I've been using them for a few years with my B&W. You can stack them and trim down the width to get exactly what you need. I left mine a little snug so the pin...

Leveling makes no difference, I've seen BC still work fine with 4"+ lifts. You'll almost certainly have to run a Lane Keep Calibration via FORScan if your installer does not do it. I kept a mild 2" rake with my coilovers, and even then the Lane Keep was a bit goofy before running the calibration.

I just went down this rabbit hole and found the Bambu P1S to be a solid recommendation, but not necessarily cheap. Basically plug and play, with options for more advanced configuration to grow into. I went overkill and got an X1C with an AMS2. Still only using PLA+, but haven't had a print...

This is the general recommendation for Tremors; I'll be doing the same next year. I'd just trim the bash plate if it gets in the way.

That's bullshit. 'Wear Items' is a defined term in the contract: They might be trying to exclude the repair under this: I would talk to the actual warranty folks to get the opinion first hand.

Someone yanked your sh*t. Go talk to your seller if they're reputable.

The throttle response is great and how it should have come stock, my initial reaction was full-time Sport mode, without the hanging gears. The shifting logic greatly improved for me, feels much more natural and predictable. My mileage is definitely improved if I can stay off the throttle; I...

No problem and I could very well be wrong; I went off the Marking Diagram in the data sheet: Best of luck.

https://www.f150gen14.com/forum/threads/can-active-park-assist-2-0-be-installed-when-parts-are-available.13767/page-9#post-313019 https://www.onsemi.com/products/interfaces/wired-transceivers-modems/ncv7424 https://www.onsemi.com/download/data-sheet/pdf/ncv7424-d.pdf

I have the RokBlokz, but took them off a year or so ago. Nice thing is once the mounts are in place, its just a few screws and they come off easily.

Looks like I used 2 for accessory and 4 for constant power.