Recent content by Matt_Bonilla08

My truck is actually a 2wd. However both 4x4 and fx4 have been tested and there is no height difference. There is only a slight difference in the shock valving from the factory.

I haven't felt any abnormal vibrations or any shudder at idle. Occasionally the shifts feel funky but I think it just may be a characteristic of having so many gears and the computer trying to hard to be efficient. For the most part the shifts are normal but once in awhile it skips a gear in a...

At this point I wouldn't be able to give you an accurate ETA but definitely months out

Is your truck 4WD or 2WD? I want to be clear that we do not currently list our clip height adjustable shock for the 14th gen 4wd trucks right now as we are making a new shock specifically for this truck. We needed to move the bottom clip down so they do not get too much lift. With that being...

Got it. We didn't see any difference in the front on the max tow truck but OEs also tend to have a specific part number for everything and most are such a minor difference it doesn't really make a difference to us

Went to king of the hammers this weekend in Johnson Valley and became the media support vehicle for our team at Eibach. Tons of cool trucks out there and drove a few trails to get around the event.

Max Tow does have different leaf springs obviously and comes about an inch higher in the rear than the standard models. The individual parts will all have different part numbers if they are max tow specific.

No ETA right now. We have not seen a tremor as of yet. But when we are able to get one in that is local then we will test fit our existing product and go from there if we need to make something new.

No problem! 1/2" should get you pretty close you may need to go down a hair more but once installed on the truck it's far easier to go down than if you need to go back up. Again I can't speak for other companies but 1 out of 4 of our applications for the 13 Gen worked out which really isn't...

Lots of great questions. Yes, the Gen14 trucks have slightly different strut mounting. Our clip groove adjustable shock will be lowering the bottom groove as well as limiting droop slightly because that spring has a bigger body and touches the upper control arm using the previous shock. The top...

The 13th gen worked great on the 14th gen 4WDs. we cycled the suspension and confirmed the valving was still good on the coilover. Our standard clip height adjustable shocks did need to be new as the clip height needed to be adjusted slightly. My truck however is a 2WD and we did have to take...

I've driven both in the previous generation. I didn't feel any difference but I didn't drive them back to back so any small differences I wouldn't be able to tell. We have put both shocks on a dyno though here at Eibach and there is a very small change in valving between the two. Basically just...

Yes that is the alignment kit. It is good to have regardless of the amount of lift since the bolts for aligning the truck are just slots making it near impossible to adjust properly. Without those you can really only fix the toe. Unfortunately we can never get enough to keep them in stock for...

I have always left mine in night mode and it still happens once every week or so

Looks great! Definitely would consider with custom paint being an option and more serious camping trips in the future