Recent content by jmorriz

it would probably be cleaner at pin 37 but a ground is a ground.

This was a splice in the wires.

The APIM asbuilt has to be loaded first. then at the bottom you will see the option to load the file from disk.

I've learned since using this there is a better, less expensive way. Order connector 6U2Z-14S411-JB and connector to your existing 54pin APIM connector. APIM connector pin 1 is 12 volts positive, pin 37 is the ground. APIM pin 1 to display connector pin 1 APIM pin 37 to display connector pin 4

I would actually start with a profile load using Forscan from an XLT with the 12" screen. Then change or remove the items that apply to the XL stuff like the backup camera. I've attached the profile that is working very well on my XL.

I believe this is the forscan line code I used. Also believe this is the switch part number. FL3Z-9C888B

It all came as a complete kit from Infotainment. I didn't not the part numbers for the trim pieces.

The back of the 12" screen has 2 connectors where the 8" has 1. The second connector on the 12" screen is for power. I removed the connector from the adapter and found a power source under the dash to provide full power when the key is on. The screen works perfect with all the features. When I...

Thanks, I installed it myself. I got the kit from Infotainment.com. It came complete, I just had to figure out how to take the dash pad off and replace with the new one. Took about an hour I would guess.

yes. I ended up removing the power connector and using it because it wasn't a true pass through and was missing pins for the camera and satellite radio. If you don't have satellite radio, the only thing to worry about then is the backup camera.

I got the adapter from a vendor on Ebay. I could see the adapter in the picture of their full kit. Be careful to make sure the adapter is a full passthrough with the added power connector for the second connector on the back of the screen. If it's not a full passthrough, you may lose features...

I finally have some of the upgrade pictures. The 12" cluster with. The orginal was the 4" cluster. This is a shot of the bed that has the Bedrug, Boxlink and factory bed lights that I installed. Its all covered by a tri-fold cover. This is the 12" Sync display. The truck did not have...

Update: figured out that you have to provide power to the second connector on the back of the screen. Found someone that had an adapter that provided the power and everything works now. On to the next project.

Thanks, I actually got the cluster and console shifter from them. Great products and easy to install!

I will get some shortly and post.