Recent content by gijoesgt

That will be fine as long as the pins line up. How tall is the total height of current block?

You could try to take one block out on each side and see how you like it. It might work good. About 10 or 15 minutes on each side to try it. Just make sure you have another inch of threads to tighten it back up.

And one more thing… I have seen several F1 50s that are 4 x 4’s with 2 inch blocks and from the factory they stacked double 1 inch blocks

Here are some sources for different height blocks Again, you do not need to get it exactly perfect. I have done this on at least five trucks.

Just crawl under there with a small tape measure and measure your block and then look for one about a half an inch shorter. I’m guessing you have a 4 x 4 assuming it’s newer than a 1997 model you’re probably gonna find this about 1.25” to 2” so you could buy 5/8 block or 1 inch block. By the...

I would leave a tad bit rake to facilitate loads, but if you don’t care about that, and you just wanna take out a half inch of rake I would change the rear axle blocks to slightly shorter, which will accomplish the same thing from an aesthetic standpoint and will not create additional stress on...

Sold

J&L oil Separator catch can for F150. New! Never Mounted. Sold Truck. Save 30% $110 shipped. SOLD GI Joe

You can use just one and split it. As mentioned you would not have left right control ability, but on most apps, it doesn’t matter anyway because their instructions usually tell you that they are mixed internally (left and right for sub) On my ranger raptor, the rear speakers and sub are powered...

Maybe transmission shifter module. Ford can diagnose.

10-4 Will do!

I tried it but no Bueno...

Yes and I have it turned off...so that will turn off the audible for the rear but not the front. Heck I dont even have a problem with the stupid thing being there as a reminder while the belts are red, but once you click it and comply with Uncle Sam the thing should immediately disappear...but...

I've searched and found some general info ( mostly about rear seat belts) but I want this seat reminder graphic to go away. With a recent update it sticks around waaaaay to long after selecting drive and pulling off and it forces you to select OK every time to remove it or wait and the wait is...

Brakes are power stop z36