Recent content by Eddie2021

I working in a Ford dealership for over 26 yrs and i could see watch vehicles had a lot problems and which ones didn't. So with that there will always be some out just have bad luck there but usually the majority of use really like our vehicles . I have a 2024 F150 King Ranch Hybrid and after...

I think it would not work at all.Plus tailgate isnt flat like the reguler tailgate as from what i see the pro acess tailgate has a rasied center.

It would be a different part no but yes other wise it should be the same as far the backing goes with all the clips. Again they all have to be removed along with any other screws and hard plastic rods and smooth out to fit flat agaisnt tailgate.

Ford.oempartsonline.com part number ml3z99425a34bb much cheaper then buy at dealership. Good Luck

Let us know if you did get the bed camara

This is w the at keeps showing up.

Everytime i sign into my accout i members profle shows up on the left of my screen. When i first sign up i got hold of this member and since then his picture of his truck and proflie keeps showing up . Anyone know how i can remove this. Thanks Richard

He shaved all the pins off and any high spots and then used the strongest 3 m tape. It fits tight and and fits up right against the panel.

I guess anything is possible but highly think that it would not work out or look very good. It would have to be a very specialty shop that would have to try to fabricate it.

Here are the places and parts of All the Chrome Parts, Tailgate applique. fordoempartsonline.com Mirrors ML3Z-17D742-FA, ML3Z-17D743-FA Applique ML3Z-99425A34-BB Amazon Tailgate Handle Cover SIZVER Triple Chrome Plated Tailgate Covers Trim Illusion Snap On Chrome Car Door Handle Cover

Amazon Sizver Triple Chrome Plated Tailgate Covers.

No they just do it. I ususally take one off the rear just haven't gotton around to it. Thanks

Go on line and get them from ford.oempartsonline.com much cheaper then going throught your Ddealer. Part nos. ML3Z-17D742-FA ML3Z-17D743-FA

Ok, he had to cut them off and shave any high spots. he did leave the black backing on. After it all was smooth he then applied 3m tape all along the outer edges and half way in the middle and any where else he thought it would work with out any bulging. Had to remove the King Ranch emblem from...