Recent content by Cheeeese

Used the ford ones, but mostly for looks. Seeing the light colored paint in the gaps bothered me.

23 5.0 with 10k on it and have replaced already.. It’s a pretty common issue, many have upgraded to a larger battery and gone away from the stock motorcraft. If you are like me and don’t drive the truck a lot, a tender is another option. A lot of threads on here to let you know your options for...

The powerboost was never able to fit an H8 with all the extra magic stuff in there. I believe they used to come with an H6 from the factory same here.. no PB, but that’s what I have read in my time here

just looked at my order, this is the part number I used. KL3Z-10A687-C Fairway Ford parts is showing it as discontinued now though.

Just replaced my H6 with an H8 on my 23 5.0. Cables worked fine, but did replace the blanket with the 3.0 diesel one (Did not attempt to squeeze the smaller one on)

I do have a MagSafe charger plugged into the front cubby area, nothing else that I know of.

For the last few weeks I have been getting this TPMS warning. Truck doesn’t get driven a lot since I commute with a company vehicle. Sits on a tender most days. When I do use the truck, it’s to pick my kids up from daycare, about a 25 minute ride there and same back. Warning will usually come up...

My wife laughed at me for doing it as well! Spend this much on a truck, may as well get something to remember it by! My frame currently is 3 window stickers deep.. nice decor for the garage!

Any chance of insects flying/crawling past the interior motion sensor? Had a fly once in my 17 250 that drove me nuts setting the alarm off..

I got out.

Leather seat replacement covers installed! Nothing like leather when it’s 10 outside, ended up working in the living room!

From an avalanche owner who now realizes I need to remove my sport sticker, I say remove it completely.. very clean looking.

Yesterday I spent some time under the truck with Fluid Film, and installed rear wheel well liners from Ford. Today I installed a new H8 to replace the little fella H6 and hopefully quiet down some of the low voltage issues. Waiting on the extension wire to get the NOCO Genius 10 wired up and...

Going the cutting route, resale isn’t worth the chance of breaking the clips and ending up with the seats not looking tight.

Watching the videos the seller sent, did you cut away the originals or try to get them out without cutting? That’s a real no going back option! Haha