Really? That's a 44 lb tire. I've got OEM Pirelli Scorpion 275/60 R20s on my 2121 KR PB. I'm looking to replace them soon, but I sure would like a lighter tire.
I ordered it and did that too. Looks perfect, and I have the switch module left over in case that ever breaks. Not hard at all. Anybody wanna buy a set of buttons, with or without a broken bezel? :)
I tried to go to your link to get the Modifier Guide, but apparently they have changed fleet.ford to fordpro, so the link doesn't work. Could you pm me the document? (or some other way for me to get it?)
That's crazy! Here in Houston I pay about $6.75 for covered parking, and I thought I was getting ripped off. It's up from $5.50. And if I take the wife's C-Max Energi (PHEV), they have free charging.
Closes and locks the charge port door and front and rear trunks, turns off the following: walk-away auto door locking, auto wipers, parking assist chime, Sentry mode. Sets climate controls to recirculating. There may be more, but that's all I'm sure about.
I appreciate the advice. I do take it on trips on the weekend and periodically during the week (including camping - fortunately my TT has A/C). I haven't ever taken it to WOT, but I can sure add that to my list! "But officer, f150gen14.com said I had to!"
With my current job, I have a half-mile commute each way during the week, not too hilly. The 3.5 never even warms up, and I don't know if you've seen the gas mileage on that engine while cold, but its about 7-8mpg. I get that twice a day, since it won't run very long on battery. If you know a...
I can't be the first one to ask this, but none of my searches came up with anything. How hard would it be to add a battery in parallel with the PowerBoost battery to increase the amp-hours available? Would it mess with some setting or charging ability of the system?
I have the laptop table (probably not really called that). On the front there is a latch that opens the center console, and on the back there is a latch that allows me to flip the top half of the center console cover over and have the flat work surface (after stowing the shifter, of course). Do...