Recent content by 1lowcourier

Along side my '23 F150 is my '74 Ford Courier

No problem and thank you! I love it and adds a bit of protection. The active air dam had to go once I lowered the truck. It kept hitting the ground and was bound to break and it looked stupid. So I went this route

Been a little bit since I have done anything to the truck. Just added Inginuity Time headlights and I switched out my tail light harness for one that is for led with blis. Now I finally have that working along with cross traffic alert. So far headlights are pretty good. Haven't had the chance to...

Little update, I depinned the 2 wires I needed out of the old harness and added to the new one and bingo all is good again. I taped up the 2 wires I needed to take out of the plug that goes to the tailgate as I may need them at somepoint for the electronic handle. Now I need to find the correct...

Yeah that seems to be the route I'm currently going to do. I started looking into my old harness and comparing pins with new one. In the pic left one is new and right is what was in the truck. Just not real sure what pins are what. There is only one pin missing on the new one compared to old and...

I appreciate the help

My original harness is ML3T 13A409-AGJ and new harness is ML3T 13A409-FAJ

I changed the tail light harness when I added the blis. I never paid attention if it did it after that or not. I just noticed today as I thought it was odd it opened when truck was locked. The new harness is for trucks with led and blis tail lights.

I recently noticed my tailgate isn't locking or unlocking when I lock the truck. Where does one look in forscan to make sure I didn't shut it off or something by accident. I just recently added rear blis so maybe I did something g when trying g to figure that all out. Any help would be appreciated

Is there a setting in Forscan that will allow to input destinations in navigation while driving

Finally did this today. I swapped to the ML3T-13A409-FAJ harness. Using this harness eliminates the need for the adapters for the Morimoto tails which is great if I ever decide to switch to the factory leds, no adapter needed. Do I need to run a calibration for the SODL/R or no. I don't have any...

Have you had any issues or codes come about since you've installed it. I just installed mine today in my 2023 2.7. I left the tube out as well currently. I only had a five mile trip back to the apartment from the jobsite so not sure if more time would be needed to see if the check engine would...

In the spreadsheet under the common tab you will see enable keypad. Those are the changes that need to be made

When I added the 360 cams I swapped out to the Tremor emblems front and back

I definitely recommend Infotainment. I bought my APIM through them when I did my screen swap almost 2 years ago.