Behind the grille LED pod mounts: DIY install

[Blown F-150]

Nice install! Looks pretty clean and a nice spot for the pods to be!

Sponsored

 

[powerboatr]

Yes up h8gher in the grill
They look like they belong

Been all over the map deciding on more lights
Higher up..is beat
But thos a pillar ugly mounts distract from trucks lines

 

[honda250xtitan]

Here’s an off the shelf option!

yep, love your kit you sell. i've had meh experiences with lights that low for out here in the desert. i built a bracket that held 4 squadron sports in the lower grille of my f250 and it was too low.

 

[SpaceWhiteF150]

yep, love your kit you sell. i've had meh experiences with lights that low for out here in the desert. i built a bracket that held 4 squadron sports in the lower grille of my f250 and it was too low.

True, my mount is mainly for fog light beam pettern pods!!!!

 

[honda250xtitan]

thanks mods for moving this to the correct subforum.


i have not looked. do you want to kick on aux lights with the parking lights? if thats the case you could get a marker bulb plug, male and female version, some wire, and than a third plug to go to your aux lights. IE copy the Starkey harness I bought but with the correct plugs to utilize the factory marker lights. fog lights do run with the marker lights only via the factory switch, it is a cool look. morimoto/theretrofitsource/headlightrevolution (all the same company) sells splitters. you might find the right ones there. on a previous truck I used a headlight splitter to tie in to some baja designs I had mounted inside the headlight housing to work as high beams in addition to the bixenon funciton of the projectors I had also mounted inside the housing. (alumiduty headlights have lots of room for activities)

 

[SpaceWhiteF150]

Correct, it looks like this:

 

[honda250xtitan]

Ohhh. Yea those are cool. I’d use their harness and tap into the oem parking light wire.

 

[rush88GT]

Here’s an off the shelf option!

Where did you get the bracket for this kit?

 

[SpaceWhiteF150]

Where did you get the bracket for this kit?

Check pms!

 

[honda250xtitan]

Check pms!

tough to beat the clean bracket for the price you sell.

 

[Henfield]

Sick looking. The 2025 with black appearance and smoked Headlights cry out for blacked out LED lights like yours

 

[JDaleo]

Check pms!

Hey, i'm also looking for a way to mount two fogs in that location. I have a front plate in the middle, but have the space on both sides of it to hopefully fit 2x 4" lights (https://www.amazon.com/NAOEVO-Inch-Driving-Light-Harness/dp/B0D148B6DX). Any suggestions for that? I got 2x 7" lights that are driving/fog and mounted them on the hood by the windshield, but they're too close to the windshield for fog lights and reflect really bad off of the hood, so i was going to swap them for just driving lights and turn them up a bit, and put the fogs in the lower grill area so i could ride with them on. The extra driving lights would just be for in the mountains and when remote with my camper.

 

[SpaceWhiteF150]

Hey, i'm also looking for a way to mount two fogs in that location. I have a front plate in the middle, but have the space on both sides of it to hopefully fit 2x 4" lights (https://www.amazon.com/NAOEVO-Inch-Driving-Light-Harness/dp/B0D148B6DX). Any suggestions for that? I got 2x 7" lights that are driving/fog and mounted them on the hood by the windshield, but they're too close to the windshield for fog lights and reflect really bad off of the hood, so i was going to swap them for just driving lights and turn them up a bit, and put the fogs in the lower grill area so i could ride with them on. The extra driving lights would just be for in the mountains and when remote with my camper.

Definitely, that’s what my solution does!

Buddies truck pictured:

Sponsored