Anyone looked into Retrofitting push to start

[Zhenes]

Has anyone looked into. I know on older trucks you had to replace bcm handles add 2 antennas and key barrel. Anyone know about how to on these trucks

Sponsored

 

[TeeJayHoward]

Has anyone looked into. I know on older trucks you had to replace bcm handles add 2 antennas and key barrel. Anyone know about how to on these trucks

I started looked into it. If I recall correctly, some pins need to be swapped around at the BCM connector. For example, the signal to "start" was was (making this up) pin 51 with a physical key, but pin 24 with a push-button start. I can't recall if the door harness has the correct wires/connectors for the new handles or not.

 

[Zhenes]

I know on the 13th gen they had to replace the bcm I wonder if it is the same for these trucks

Sponsored