Search results

I ordered from https://ford.oempartsonline.com/ but the dealer it came from was broadway truck. I must have ordered at a good time, it shows like $80 from the same website I ordered it from.

Those of you that swapped the harness out. Whats your plan for the old harness?

This is what I could find real quick. Not sure why you wouldn't have a spot for those plugs to go though.

Did you use the harness part number from the earlier posts? If the plugs are at the ends of the bumper I'd assume its for the distance sensors on the outsides of the bumper for the platinum plus models or models with the park assist.

These are the part numbers that I ordered. Disregard the pillar and keypad ones unless you want to add those too

I was looking into some wiring diagrams from a workshop manual last night comparing the pins that were populated in my current bumper harness vs the pin out on the connector from the workshop manual of a 24. I noticed I have pins in the connector that says they're unused in the manual. I pulled...

I've never actually ordered from him but I liked how he actually carried decently priced parts, seems like all he does now is harnesses which doesnt really interest me any. I've also heard from a couple places about the long wait and poor communication. On a side note if it isn't too much...

Haha where were you at 3 months ago. I would have much rather done it that way. Do you happen to have the part number of the harness you verified? I'd still rather have an oem harness and willing to take my bumper back off for it

It was just bad lighting in the picture i seen, Its identical. I thought some 24 lariats without the black apperance package had chrome in the foglight besides the reflector portion but it seems like they all look the same... id still try to stick with oem but i also understand the value in...

From what I could tell they didn't look the black housing ones if that makes a difference to you. Honestly anymore it really is you get what you pay for, they'll probably work good for a while,maybe a year or two, but id expect to replace them after a while...they may look identical but the...

Do you normally run your foglights on at night? Could be that the cornering lights are turning on and off, which is just If the foglight switch is turned off then the foglight of the direction you're turning turns on.. other than that youd most likely see an issue with the drl at the same time...

Flickering sounds more like a poor connection somewhere? Are you seeing flickering from the foglight or the DRL or both?

No, they have basically 3 power wires and a ground. A constant 12 volt, a switched 12 volt for the foglight, one that varies voltage for the drl, and the ground.

That's basically all these adapters do is pull the 2 wires from the headlight circuit with some extra steps to alleviate modifying the OEM harness. All you really have to do is tap into the wires from pin 3 and 8 from the headlight and run down to foglight connector to pin 3 and 1. Then the...

I think for most people they don't want to modify oem wire bundles. You absolutely could do it that way. You may also be better off just tapping into the headlight harness instead of the fusebox since all the wires you need are already ran there.

Awesome work. It looks great. I was super close to getting that exact truck but went with blue instead.

One end will plug into your headlight and the other will plug into the oem headlight harness... i would plug it into the headlight first then plug into the foglight once you put the bumper back on. If you don't want to take the headlight off i was about to reach behind the driver headlight and...

If there is a red tab you need to pull that back first and squeeze the back side. It has a seal in it so it may be fairly snug

They should be only torque to like 80ftlbs. Mine were pretty tight but i used a standard sized 3/8 ratchet and a sturdy stance and they came off just fine for me.

If youre going to do it from the bottom though I'd put some blocks of wood or something under the tires to lift it up a little more. Was night and day difference when I swapped intercoolers out.