Search results

I figured out the illumination. The culprit was my ground wire. Thanks @billp9… just want to clarify some things from the write up that worked for me: Upfitter switch pin … relay pin 9 … fuse 2 (hot in/acc delay) … 12 1 … 5 for illumination 11 … overhead (c930) tap violet/gray wire 6 …...

No illumination for me, I’ll try a different tap… not sure the tap I’m using is piercing the insulation correctly

I’m confused on the ground, the fuse, and the hot in line. 1. If wire runs from overhead pin 9 to relay pin 12, do I need to tap that wire with the add a fuse? If not what is the fuse tap powering? 2. Ground runs from overhead pin 6 to relay pin 1, do I need to tap this wire and run to ground?

How did you make the bracket? Was it necessary or could it be held in without?

Has anyone found the paddle shifter connectors and aftermarket paddles? I’m wanting to do an aftermarket wheel in my 21 XLT but there is an expectation that you already have the raptor connectors…

Can you send me this info as well? Thanks!

Anyone have issue installing this rear emblem with Morimoto Xb taillights? My emblem and the taillight that it’s connected to won’t stay lit after putting it the truck in drive

Thanks all!

21 XLT 302a job 1 truck with front, passenger, and passenger rear connectors. I successfully installed the jumper wire included with John’s harness from c2280 to c212. I successfully made the forscan changes and connected both front footwell lamps. Turned on the ambient lights through the new...

I believe @TylerNinetyTwo made the brackets, but he has a 2WD (maybe different frame) which may be the reason he needed the brackets. @TylerNinetyTwo is your truck also a job 1? Do you have pics before the skid plate install of the front holes behind the tow hooks? Thanks in advance

Has anyone figured out if the kit can be modified to fit a Job 1 4x4 XLT? @fordtruckman2003 @TylerNinetyTwo Any thoughts? My truck has a build date of 02/2021, hole spacing looks off compared to other pics in thread…