Search results

Didn't think about my tires. Pc blend ratio is greyd out. Question about break actuator release delta. What does it do?

Yesterday the temps were in the middle 30s I had far less trouble in the curves. I suspect temperature has a bearing. Is there a way to adjust sensitivity? Or might it be torque?

Dang I totally forgot about the Ford settings. Thanks. The other day I posted about my truck over correcting in curves on interstate. Its late in correcting its center at the start of the curve. Gets close to the inside or outside of the lane marker and then decides to correct by...

Speed limit control. What settings do I look for. My truck gets the data but my truck is no longer responding. 2.2 ford control. Funny thing is I haven't touched a thing in 10 months

2022 f150 hybrid. I know how to set things up to keep the truck running. Tow mode with electric brakes on. But how can I keep the generator running and still lock the doors? I have to place the brakes on and shift to netural. When I lock the door it shifts into park and shuts off the...

Ok. Also I had asked earlier. Will 2.1 work on the new comma? I read from them that they welcome other forks. I assume yes but does it feel the same? I prefer to use 2.1 for the original chill mode and fewer nags. I purposely avoid updates. I apologize for not recognizing your hard...

Yes I understand it doesnt morph and im confident my suspension is ok. Its like the sensitively in just curves are too high. Its over correcting. So far I have done a reboot. I will try a calibration next. My mount is solid. I could try a full wipe and reinstall. Can you please give me...

Should I be concerned about maxed out memory?

New issue just started. On interstate im centered and stable. On curves at 70mph it starts to hunt for the center. Eventually starts to ping pong. Grows until its violent and crosses both lines. On version 2.1

Hey Allan. I run the older version of bluepilot. I forgot the version. I haven't done any of your newer releases. Chill mode? Version 2.1 Will the comma 4 still work with that version?

I know first hand how fast things get ugly. I was towing a 6 place snow mobile trailer with 6 sleds strapped down. Going through Nebraska i told my buddies I didn't like the feel. I suggested we pull over and move the tandom axles back a foot. The steering was way to light. So while we...

Someone just suggested something about the hybrids alternator smart charger algorithm. If the agm batteries are fully charged the alternator get set into a low output mode. Some dump trailer chargers wont turn on unless there is sufficient input voltage. Even though there is a 12v...

Well I can start with pinging out the 12v. I know the truck sees the trailer. It compleats the lighting checks, shows the brake gain and disables side sensors. I have the truck running in park and go to the trailer to observe the status lights on the charger. There is supposed to have a...

My trailer has a multi input charger. 120v, solar, and truck. Im not getting 12 volts on the 7 pin connector. Is there something I need to turn on? What pin is the 12 volts supposed to be on?

Simply replace the modual.

Im sure going forward from 2025 the cable and connector will be removed. Has anyone followed that connector back to the module or a wire loom? Also. It seems like a coincidence that the securcide button removal occurred at the exact same time when ford started encryption. Could ford be...

Read Sunnys post today. Im not sure what that means going foward. Is openpilot receiving grief from manufacturers?

That's an excellent idea

I did some research since my question. I have a better understanding of how the encryption works. Sucks that I will never be able to maintenance anything newer or even do performance mods. Won't be able to do brake jobs.

So tron is in the apim? Could a older apim be swapped? Theoretically?