Search results

Does anyone else have two ghost notifications that won't go away and a new story from the Porsche Macan forum? Just want to make the admins aware if its not only me.

I know this is a Gen13, but it still seems concerning.

Does anyone happen to know the part number for the push pins that attach the grille to the active grill shutters in the front of the grille? The ones I am looking for are circled in the picture below. I have looked everywhere and have been unsuccessful so far.

Does anyone know if only the orange portion of this connector with the locking tab can be purchased? If so,do you happen to have a part number? Mine decided that it no longer wanted to be attached while I was disconnecting it today.

For those anxiously awaiting a Gen 14 F150 sound treatment installation video, the time has finally arrived. Courtesy of our friends @SoundsGoodStereo.

Has anyone added open cell acoustic foam tiles (ex. Blackhole or Guardian) behind the speakers in their doors with no other changes to their aftermarket sound system? If so, was any improvement worth the cost? I plan to add ~70% CLD coverage as well as front and rear block off plates, but I am...

I'm fully aware that this is a volatile topic, so I will lead with that. That having been said, with an amp that puts out 50w RMS to the two front channels, what does everyone think about Kicker KS 6"x9" front components vs. the Alpine S2 8" front components? Both will require custom mid bass...

I'm looking to add a Kicker Key 200.4 along with Kicker KS speakers to my truck. I know that the Key has DSP, but unfortunately the tweeters share the same channel as the front door speakers on the 7 channel arrangement. Does anyone know if there is an existing high pass filter on those channels...

While installing a replacement ACM yesterday, I dropped a nut driver bit into the dash. It sounded like it played plinko for a bit and then landed somewhere near the bottom. Does anyone have instructions for removing the center kick panels so I can attempt extraction?

Does anyone know the bolt size and thread pitch of the bolts used for the bed extender?

Did anyone else get an email and letter for program 23B24 regarding the tailgate step grab handle?

Does anyone have any suggestions for anti-rust coatings for shocks? I've heard that Bilstein shocks do not fare well in the rust belt and with winter just around the corner, I want to do what I can to prevent rusting. I'd prefer not to use something like fluid film, surface shield or woolwax...

After a bit of reading, I realized that converting from LED reflector to LED projector headlights, while maintaining all of the projectors original functionality (such as cornering and auto leveling), is quite involved and requires numerous additional parts. Does anyone know if a conversion...

So I installed some new Tremor LED tail lights this morning and the physical installation went smoothly. I was not so fortunate on the forscan front however. The instructions only provided values for the as built format. I went into the BCM and made the first two changes without issue. The third...

Does anyone know if it is possible to disable the active air dam via Forscan? If so, I would like to do this for the winter to prevent it from being damaged or torn off by the snow.

I purchased a set of what I thought to be genuine TPMS 68 sensors for my new wheels and tires from a vendor who I've purchased multiple sets for other vehicles in the past from without a problem. Unfortunately, I cannot get the truck to recognize the new sensors when its in learning mode with...

So I finally got around to installing the Ford Performance front struts today, but I just ran into a problem. When I install the strut the only way it goes in on the top, the bar pin at the bottom is 90 degrees out of alignment. Is this something that will require the spring to be compressed and...

I've recently noticed that if I take my foot off the brake and allow the truck to slowly roll down a hill I consistently get a transmission cluck and a substantial jolt inside the vehicle. This usually occurs on the same section of road that gets backed up on my way home from work. Is this...

Out of curiosity, I decided to replace and inspect my oil filter after the first 2,300 miles on the truck. I felt it was too early for a complete oil change, but I wanted to have a look to see how things were going. After opening it up, I was pleased to find only the expected sparkles from...

I know that many are not a fan of the auto wipers on the F150's. However, since the stalk for them will be included with the SCCM that I will be purchasing for the heated steering wheel upgrade, I was wondering what else would be required to add them. From what I can tell, I will definitely need...