Recent content by Weller12

That shouldn't be hard to check. If you still have everything changed with forscan. One of the pins in C2280E should be a momentary ground. If you tap that to ground then it should trigger power to the other pin and turn on the lamps in the chmsl.

I looked in the IPC and there are about 15 lines for seatbelt chime. Most of them are off but I believe there are 6 that are enabled. Should I disable those? Or where do I remove the seats? Will removing the seats mess with heated seats.?

Does anyone know if the FORscan changes on the first page are the same for a 2025? I know some changes differ. I have a camera and harness i just need to run the wires to the modules (I am not that intimidated as long as i can get the correct pins ordered)

I ordered the light through the dealership. It came with the harness for different headlights than what I have so I will have to repin the included T harness since the bcm doesn’t like this light plugged into the side marker light.

I know this is an older thread but would these by chance be the same parts for a 2025?

This is now on my list of things to add to my truck. Harnesses are very easy to build once you know what size pins and connectors to buy. DigiKey is a good source for harness connector parts.

Ok big question here I want the actual button on my HVAC controls is there a controller that has heated seats and heated steering wheel without cooled seats? if I have a cooled seats button I will be tempted to figure out how to add them.

Thank you for this. I am looking at adding rain sense Chmsl camera Heated steering wheel. This comment helps with 2 of these for sure Now if I could only find an hvac controller with heated steering wheel heated seats but no cooled seats. (Idk if cooled seats is a rabbit hole I want to dive...

I know this is for a slightly older truck but See if this thread helps you any. https://www.f150forum.com/f118/led-box-light-not-working-539412/

I think I am getting closer to figuring out your wiring to the BCM. See if this helps you any

I just ordered connectors to make marker light splice connectors (I already have the pins for the connectors) but I also ordered the male pins that I believe can be added to your bumper harness in spot 28 & 31. I will post a link to the pins if they are correct. I could actually post links to...

I might be getting closer to an answer for you. I found this thread on a different forum for a 2018 300a. I joined to forum so I could ask about your truck

I am searching to see if I can find the answer to your question. What package do you have?

I took the connector apart today to look at the pins and I happen to have an old reverse camera from my wife’s Tahoe that had the same pins so I clipped 2 of them off and soldered the wires to my custom harness. Here is what the pins look like but I still can’t find the actual name of them. I...

To add new pins I just pulled the white/clear center piece out it pops out pretty easy. Once you do that you can insert your new pins very easily. I pulled the plug wire in the photos just to show what the correct pins look like.