Recent content by Wallick

Here’s a picture of the part number and harness. You can see the top left(pin1) on the brown connector has an extremely short coax to the new brown connector that would normally go to the APIM.

Stick a pick under it at an angle towards the left or right side back and forth prying up and it will pop right out.

Hey @ Tlusk7 Finished install (except cargo cam) but having an issue that none of my cameras work I get a black screen then this in reverse and nothing comes up when I press the camera button on the dash. IPMA was flashed by Jesse. Also the IPMA-APIM harness (part #ML3Z-10E929-BLA) pin 1 was...

Did anyone happen to get the part number needed for this IPMA-APIM coax cable?

Submitted !!

My 2021 rcsb 3.3v6 (45k miles) recently got a check engine light for P0171. It also shows a couple other codes seen in the attached picture. I’ve changed the MAP sensor and bank 1 sensor 1 o2 sensor. The codes still come back. Does anyone have any input on what it could be. I am unfortunately...

UPDATE- I had also swapped to the lariat key hole/dash trim and it must have some type of metal inside that was affecting the key signal. Removed that trim and the truck starts like normal now.

I swapped my dash pad in my 21 xl to a lariat one. Used the donor trucks airbag just for ease of install. Truck started fine last night, but this morning it won't start via the key only with ford pass app. Is something upset with the airbag system that I can reset or do I need to reinstall my...

Looking for some answers on this too. Seems like nobody wires the console in which seems crazy to me.

Came to make the same post. I be been digging for a few hours with no luck on a part number or aftermarket one listed