Recent content by treg00

This little bit of information, particularly that it should make a noise when snapping into place, had me go outside and reevaluate and I fixed it! The issue was that they had them on the wrong sides, or they were upside down, however you want to look at it. I pulled one off and flipped it...

Thanks! This is what I was wondering if there was any detailed install info, I guess the answer is no.

2022 F150 with sunroof. I had the entire sunroof replaced via warranty work due to a seal issue and these two black plastic accordion side vent things that expand when you open the sunroof in vent mode were not secured to the top glass when I got the truck back. They are secured at the bottom...

I bought a 22 PB, and the only issues I had were of my own creating. I put a 2in level on the front end which allowed me to increase my tire size slightly. Those changes made my onboard scales inoperable and the speedometer off by 1 mph. Three dealerships could not help and I was very...

I have the bracket, not sure about the harness, but I'll check. I see some posts about adding adaptive cruise after-the-fact. I am not interested adaptive cruise at all. If I have the harness, and am willing to buy the radar part specifically to augment the precollision assist with AEB...

Well, this explains a lot. I went and pryed that cover off my bumper (location 2) and of course my truck don't have anything in there mounted to the bracket. That leads me to believe that these systems with the camera-only that do not have the radar part to go with it is pretty much worthless...

Thank you!!!

This is really good info, thanks for those pages. I feel like after reading, my truck is not doing this. I was looking for the next page, 378 to see where the sensors are located on my truck, any chance you have that page too, or link me to this document?

I don’t have adaptive cruise, I only have the pre collision assist with auto emergency braking. It does almost nothing even set to high.

After reading a couple threads on this and seeing everyone's input (i.e. the system has limitations and wont prevent but rather reduce severity, especially if you're going fast etc.) I have to say I don't think mine working right even though I don't have any messages indicating anything is wrong...

For mine, when it didn't work neither screen worked until I ran the recalibration tool that fixed both screens. If you have one screen moving around and the other stuck on zero, sounds like you might be having a different problem. They don't really give you any hard numbers on either screen...

If you just need to fix the scales, there's no value edits in Forscan, just run the following height sensor calibration tool. Before you do anything to any module in Forscan, make sure you save the as-built back up file for that module in case you ever need to put it back the way it was...

Good info, thank you.

I JUST got my truck 100% working correctly again by adjusting things in several modules. Do these Ford updates mess up things you used Forscan to fix? (had to recalibrate ride height sensors in VDM to make scales work, updated BCM for new tire size, reinitialized the PCM, etc.)

I thought the exact same thing, even to the point where I thought something was wrong with my truck. But then I read the other threads, and saw screenshots, and realized that this truck has to be driven a certain way to achieve those numbers. I cannot drive mine that way. I'm too zoomy zoom...