Recent content by TexasTorque

That's fair and at least comforting that this is evidently the way it should be. I have tinkered with "the experience" a bit more since inquiring above to make sure I wasn't misremembering that it would stop if it was in a traffic flow that came to a stop. It for sure does, but not without an...

Hi all, I added adaptive cruise control to my '21 XLT a couple of months ago and have meant to come back here and ask about what I should be expecting/not expecting. Install wasn't too horrible... Had to pull the bumper of course. Added the radar and a new bumper harness. Luckily the rest of...

Thank you @antho, if it doesn't derail your morning, the new one isn't going to cut it in its current state. I actually swapped the old one back in earlier since the news above was grim. Was going to explore options a little and figured it would be better on a shelf (perhaps permanently) while...

Thank you @antho... Yup, the hard button lit up the cameras just fine. I could use the soft buttons to toggle to the different views... even the 360 view was pretty darn respectable without an alignment being run. I was pretty stoked about it until the answers started coming in on this...

That's fair. I truly didn't grasp that I was trying something sketchy/questionable, but that's on me. I just saw this part number listed here on the forum as one that could handle 360 cams and searched for one and bought it. Sucks a little, but I'm not out too much if I have to go another...

Feel like I missed a pretty important detail in all of the research... Didn't grasp that I was going rogue here! For my own education is this because the part was previously (I assume anyway) PMI'd to another vehicle or because of the shift to a totally different part number with different...

well crud.............................................

Thank you, I did try the rear parking aid alignment one earlier... I was trying to make it to the Costco parking lot before they opened for the 360 cam alignment but the general "IPMA alignment" one chewed through more time than I was expecting (which was mostly my fault) and I didn't get there...

Hi all, I've been working on adding 360 cams and have been sort of successful, but sort of not....... I had a ML3T-14G647-DS IPMA (brown camera port only) and went the eBay route on a replacement ML3T-14G647-NA. The IPMA swap was the very last step I did on this project. Best for last, right...

Hi all, I traded my stone age '06 for a '21 XLT with 302A about 5 weeks ago and, although totally unfamiliar with Forscan and all of the Ford modules, I decided pretty quickly after hanging out on the forum here that I wanted to make three changes. add 360 cams add adaptive cruise add rain...

I finally figured this out and then it sunk in that you had already told me the problem. I couldn't see up into the gray channel but could see black in it from my vantage point so it looked like it was ok. Turns out that pushing the lever all the way back like I was doing had sent the channel...

Yeah, I've pulled apart the big C316 connector under the hood which has a similar lever concept so I was generally expecting something similar once I could get the lever to release. The inner connector of this C265 one certainly pushed out a bit from the female side as the lever raised but it...

I don't know why C moves.... Probably a decoy to throw someone like me off the trail... but I raised it back up and re-tried one of my moves before deciding to humble myself here on the forum. Came at it again with a flat-head screwdriver resting under the little lip I'm pointing at in this...

That was my original thought too, but I've not managed to make that happen yet. I did go back out and press some more on C. I tried pushing it back towards the connector and it wasn't doing anything. I did wedge a screwdriver between it and A and pulled towards me and now have C looking like...

I would actually be very mad at myself! @HammaMan so you're saying there's hope... haha... do you recall which way you were applying pressure on C by chance? Like wedged in between A and C and prying the top towards you if your view was as in the picture? Or is it supposed to be more of a...