Recent content by simon

even for a battery that small? It’s fixed at 125 A, so assuming 125 A current * 0.018 ohms = 2.25 V drop at max current, which doesn’t seem totally unreasonable. thank you! I checked the fuses per your suggestion. Some of them were loose and I pressed them back in. I went on a 9.9 mile drive...

Well, in case anyone is wondering, I had the battery connected to a charger for nearly 24 hours. Afterward it still tested good with 915 cranking (not cca this time) amps. I went for a 30 minute drive and nothing changed. Any ideas on what to check? I am still getting quite a bit of “engine...

I just plugged in FORscan and have a plethora of errors, though I'm not sure if any are related. DSM: U0422 - Invalid Data Received From Body Control Module HVAC: B10B8 - Push Buttons HVAC: B1083 - Recirculation Damper Motor PCSM: U0415 - Invalid Data Received From Anti-Lock Brake System (ABS)...

Thanks, guys! To answer the questions: yes, both the batter under the hood and the aux battery are the originals The truck did not exhibit this behavior before the dashcam. I'm not convinced it's the dash cam since other members on the forum have hard wired dashcams using these fuses and no...

Hi everyone, I have a '22 Powerboost that started driving a little odd and won't go into electric mode, or on occasion it will very briefly when slowing down to stop at a red light. The second you get your foot off the brake at hit the gas with the lightest tap ICE will kick on, or often times...

I haven’t had a great experience at Ford dealerships in the Atlanta area and it really turns me off from the brand. Good luck

Did they at least give you a loaner car?

If only I could be lucky enough to live near a dealership that would be willing (able?) to do so.

it was not difficult, but you need to be very careful. Make sure to adjust both sides the exact same and a small error can result in a big difference. in your case you need to lengthen the left tie rod and shorten the right by the same amount. I’d try a quarter of a turn, maybe less. And adjust...

Thank you! It's the media bin lid itself broke. There's a spring inside of the lid that automatically closes / puts tension on the sliding part that popped out and I have no idea how to get it back in. I was going to just bu a new one, then I saw how much they cost ...

So - I just got around to doing this install and I somehow blew out the spring in the media bin lid. I somehow found the spring, but it seems to be a constant force spring (one that rolls and unrolls) and I have no idea how it goes in or flew out. Anyone have any idea how to reinstall this back...

I bought my ‘22 new in May ‘23 off the dealer lot and there have been no problems

I just left it outside overnight, without the battery charger this time and it worked. So I guess it was close to following the steps shown Simon

I woke up this morning to see the truck successfully updated. Bluecruise 1.4 seems to be a dramatic improvement over 1.0. The lane changes are awesome and it stays engaged and centered in lane so well!

Now I wonder if I caused this by putting it on a battery charger so much since the first failure. Thank you!