Recent content by Shamling90

Battery was at 12.4 when I checked it last night , had it on a 10 amp AGM specific charge overnight and is now sitting at 12.6. I have no load tester here however . VIN- 1FTFW1ED0PFC79712

I parked in my driveway after a 400 mile road trip, pickup sat for an hour or so and when I went to get back in it the first thing I noticed was that the power running boards did not lower . Upon entering the vehicle , nothing on the dash lit when I opened the drivers door . Pushing the ignition...

I have not broken any lights. I resolved my overarching issue of the Precolision and ACC not working. Somehow the bracket for the CCM was busted. Everything else seemed to be fine and after i replaced the bracket i have had no issues. Part was under $30. Used forscan to recalibrate the module...

You sure can, i may not have been clear, but that is what i meant when i said "toggle to normal cruise" in drivers assistants i switched from ACC to normal . However, when i attempt to set the cruise after selecting normal it still pops up the ACC unavailable warning and does not activate normal...

On my '23 PB I have been getting intermittent Pre- Collision front assist errors followed immediately by adaptive cruise unavailable. When i toggle to "normal cruise" and attempt to set the cruise control it chimes that ACC is unavailable. Does anyone know if i can make my normal cruise work...

I did not realize that the advanced security pack had been removed from the factory, I cant recall what all existed ( other than the interior motion sensor) in the alarms settings on my 2021 PB, is it possible that the settings screen does not exist without the advanced security pack?

Per the manual, settings for the alarm should be under settings-vehicle-alarm settings. I have looked numerous times both in accessory and with the pickup running, no alarm settings exist. Has anybody else ran into this issue and figure out how to resolve it. I believe my software is up to date...