Recent content by Riderdie757

May be a bit of a stretch, however, I feel that if you can make it through assembling a piece of furniture from ikea, you can find your way through swapping the seat covers! The one tool that made it helpful for me was a pick for o rings. I was quoted locally $1,900 for the job ($1,100...

@Stage3Motorsports , thanks for starting the thread, wish this was out a few years ago. I started with 21+ fox 2.0's (from stage 3), if I recall correctly, I netted .75in's of lift. Paid a shop to take them off and adjust to max pre-load, that brought me up to 39in (ground to fender) little...

Properly installed my running boards... Walked out the other morning to admire the truck and noticed the running boards were running the wrong direction. Works for me, they feel new again! This one took a little longer than the running boards but picked up a set of MY24 OEM lariat...

Hope i am not simplifying it to much but the area circled toggles the sync sidebar of and on.

Joy ride, scenic route!

Icon 2.5 front, 2.0 rear. Truck is a PB.

Swapped my 21+ Fox 2.0 for 21+ Icon 2.5's. Loving the ease of adjustment and a little more height on the front end (Powerboost). Just gotta start selling all of these takeoffs now...

I appreciate your reply and share your sentiments, 4 wheel parts has done mine also. From my experience with them, they are not going to adjust or modify a coilover without direction from the client (at least my local shop). Then they call the manufacturer and get the suggested rotations. I...

I've gone down an abysmal route of fox 21+ with two installs (2nd one to adjust for more height), still no where close on my powerboost. Icon seemed to be the answer but no vendors claim to have experience or knowledge with measurement of threads to get a defined level or rise. Extatic to see...

Roughly 2.5 hours south in Salvo NC.

I do intend to match it to the actual skid down the road. I will wait til the next front end mod however. Not sure of the best route, wrap, rattle or paint shop.

Installed a Tremor skid plate during the week, put it to use yesterday and today!

Used the tailgate as a kitchen.