Sponsored
ProperRCLB's latest activity
-
ProperRCLB replied to the thread LCD HVAC on 2024 Installed!.I don’t believe people swap these because they add chrome knobs. I’m not familiar how to add dual zone. -
ProperRCLB replied to the thread LCD HVAC on 2024 Installed!.It does not add dual zone functionality.
-
ProperRCLB replied to the thread 501A to 502A.Got this all sorted. Had the wrong rear sensor. -
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Here is my SCCM: I managed to get high beams to work. Pin 6 needed to be swapped with pin 5 on the 16-pin headlight connector from...
-
-
ProperRCLB replied to the thread 5.0L F-150 getting Ford Performance Calibration Tune.50HP for $700 with warranty is a bargain.
-
ProperRCLB replied to the thread Power Tailgate on a RCSB?...Yes Please! My DIY Install.No I do not need another project right now, but I'm in to sponsor $25 for @TN_Ryan to do a full write up for this so I can know this out...
-
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Blue light turns on in dash but no high beam No dance on startup Dash error “Adaptive Light” malfunction
-
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Correct I made all the changes shown on the Forscan changes sheet. The only one that is not allowing me to make is the one on the HCM...
-
ProperRCLB replied to the thread Morimoto Backup Light simple install.Looks great, the improvement is 10X!. Morimoto should make a plug and play version.
-
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.VIN updated still same error on the dash and no high beams or glare free. I have a SCCM DTCs due to a wrong switch. I'm going to fix...
-
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Not my VIN. Will update and report back.
-
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.I have not. Hopefully that solves. Are you able to share how to go about gettinng that done? I can swap an engine in and out of the...
-
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Here is my HCM
-
-
ProperRCLB replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Was able to run wires to the front and rear leveling sensors and connected the HCM and HCM harness from Ryan. Getting: - TCU Code...
