Recent content by PReam

Can anyone tell me where this sunroof slide shield fits? It fell down while opening the sunroof and I can’t seem to find where it snaps back onto.

Late to this thread but I have a ‘21 KR and the appliqué was peeling off. Had it replaced by the dealer in June ‘22 and it didn’t fix anything…still have gaps. The local dealer made me feel like I was being nitpicky and I’m hesitant to ask for another replacement.

I also experienced the appliqué peeling off. Took it in and had a new one installed and it’s no better than the last…previous gen trucks’ appliqués I’ve seen are secure and are not flimsy. Definitely a quality control issue with the new trucks. I’ve just learned to deal with it and if it gets...

I’ve had my MY2021 KR for almost a year with the PB engine. Been in the shop a few times for a few unrelated issues, but drove the ecoboost while in the shop. I’m trading my PB in for an ecoboost because of the hard clunky shifts up and down.

Update: dealer “fix” didn’t do anything. Continued shudder right off the dealer lot - waiting for an appt to return truck to service again.

Experienced intense engine/transmission shudder several times over the last few weeks, finally got so bad I would have to pull over, turn the truck off and on again in a few minutes. Has happened anywhere from 10mph up to 75mph...truck was vibrating so bad that when I was taking a video on my...

Same issue...Just picked up my truck today at the dealer and immediately realized the clunk shifting right off the lot. Headed back tomorrow to see if they can fix with what others have suggested.

So my truck came in today at two dealers (Ordered through two different ones) How has anyone dealt with the “losing” dealer (ie, how did you break it to them that you went elsewhere)? Ordered 5/6 Blend 6/22 Shipped 6/29 Arrived 7/13

Order 5/6 Blend 6/22 Built 6/23 Shipped 25 days ETA 8/4 No check mark under built yet... Anyone received their truck before the ETA?

5/6 Order 6/22 Blend Ford Tracker showing shipped with a 25day ETA, although checkmarks haven’t appeared yet... KR, FX4, spray-in, etc.

Tracker updated today! Blend of 6/22 at Dearborn with an ETA of 8/2. I opted for the spray in liner before I knew about delays, but hopefully won’t take that long. Also have my dealer doing a 2.0 level and nitto grapplers so that will take a few extra days once it arrives...

Window sticker updated today....still holding strong for a 6/22 blend! Good luck everyone!

My dealer asked for a copy of my DL before placing the order...

I’m in the 6/22 build club. Ordered on 5/6, VIN issued a little over a week later, with the window sticker following the week after. Status is “in production”. Hoping several are correct with assuming enough chips have been allocated for these blend dates for complete builds...fingers also...