Recent content by Prancer

Worried I don't have the right pins for the IPMA/might be inserting them incompetently/worried I damaged the connector pin slot when inserting one. Used DU2Z-14474-CA pins. They didn't seem to be seating all the way. Hoping I just damaged one of the pins when inserting and didn't break...

3.5 eco. I ended up taking the bumper barely off. Pulled it barely out and rested it on some supports giving me just enough space to sneak the CCM in. Will finish routing wires tomorrow and then hopefully get onto FORSCAN to finish it up. Praying for no hiccups...

Thanks a lot for that. Excited to tackle that once I figure out a path from the bottom to get the CCM mounted without taking the bumper off.

I finally received all of the necessary parts for this project. Would somebody have a comprehensive list of the required FORSCAN changes they could share with me? Again, I have a 302A with nav and am running a custom harness directly from the IPMA to the CCM. Any help is much appreciated.

Ok, ready to dive into this project. Just looking for a sanity check from those who have gone before. I have a '22 302A without 360 cams. I'm only looking to add ACC and then enable speed sign rec, lane keeping, stop and go. After reading this thread, it seems like I can make a 4 wire harness...

It's #2 for me. Found a truck with everything I was looking for except ACC. Definitely going to add it once I feel comfortable after more research about how to do it.

I've read over the whole thread. Curious if 2022 F-150s would require the same game plan/parts.