Recent content by Omodan

When I added the front sensors, MY22 just released. I would have used the tab for MY21. The other tabs didn’t exist then.

It has been a while for me but I seem to recall that digits 9 and 10 don’t really matter. They will change automatically as you change the other values. I am sure there is some logic in the system that does a reference table lookup, but I don’t know how that lookup works myself.

Changing the wiring harness did not impact my active air dam. It still worked after making the change.

I am not sure of the exact part number for the one at that location, but should be similar to this part number (ML3Z-15A862-AAPTM). i know I ordered them for my front bumper and they were all exactly same, regardless of the part number.

Thanks for the note. I’ll repost you notes on the front page.

Which areas do you want pictures of? I have quite a few taken of how the wiring harness is supposed to be connected.

I first had Air 80 on my 2019 Ranger and now will not have a vehicle that isn’t tinted at least with that. The heat resistance simply makes the vehicle so much more comfortable. I do live in Georgia though. I now have both my 21 F150 and my wife’s 22 Expedition done. It makes it to where...

In the Army we used an IR reflective tape/patch called “glint tape” for night missions so other friendly force could identify us versus the enemy. I would be curious if you could place a piece of glint tape over the IR sensors within the truck effectively tricking the truck into thinking you...

If i were you, since you custom ordered the truck and the dealer has it; i would ask the dealer to swap out the rear bumper and add the dual exhaust with black tips as a dealer installed option. I bet they would accommodate your request in order for you to buy the truck. That way you get...

I have a chrome bumper. I used the attached and it came out pretty good. Just be patient though. if I was to do it again, I would go light on each coat and give it a lot more time between coats. I ended up getting finger prints on mine when handling them as I didn’t wait long enough for them...

There is no way I would pay that for those. When I ordered them in 2022, they were roughly 55 each. I did find them on amazon for $20 each here: Magimaker Parking Sensor Compatible with Ford F-150 Bronco 2021 LU5Z-15K859 LU5Z15K859 LU5Z-15K859-AAPTM LU5Z15K859AAPTM https://a.co/d/6Pr0mR9...

I took several more pictures to help show where the cabling harness runs for the front sensors. All of my descriptions below stating either “right” or “left” is based upon a person standing in front of and looking at the front of the vehicle. The below pic is the first connection point, after...

The connection you have pictured runs to the active louver to the engine. Attached is a picture of where that connection went to on mine.

Is your primary connection seated fully? It sounds like the wiring harness for those connections is not connected all the way as the pedestrian speaker and front adaptive cruise control radar are both down stream from that connection. When I did mine, those all still worked. The only thing I...

Post a pic please so I can make sure we are talking about the same connections. If the 5.0 does not have active air louvers, then not connecting them shouldn’t impact whether the sensors work or not. My concern would be that your wiring harness which runs back from that connection point to the...