Recent content by nall

I have a 2022 F150 XLT with the 400w DC/AC inverter. Yesterday I had an oscilloscope plugged into the instrument panel power socket and while measuring a voltage, I opened the driver door. At that time the power to the socket turned off. I've not been able to get it back on. The power socket...

Yep, it makes sense that it's opt-in as the traffic of all 7 busses going into the GWM could overwhelm the DIAG1 bus otherwise. Thanks again for the response. I'll reply back to this thread if I find any additional information.

Thanks -- I'd found that connector, but was hoping I could access via the ODB based on the language I pasted. Looks like I might be cracking the console open (again)...

Hi, all. I have a 2022 F150 XLT. I'm trying to read traffic from the HS-CAN3 bus. My setup involves an OBD2 port with the DIAG1 CAN high/low (pins 6 & 14) connected to a CAN tranceiver to an Arduino sending data to a computer. I see the Service manual says: The GWM...

Following this thread for dog pics haha

Hi all, About a month ago I opened the hood and saw evidence of a mouse (droppings). I cleaned up, started parking in the garage and have tried some applications of peppermint oil. I haven't seen additional droppings under the hood since then. However, today I was looking more closely at the...

Hi all, I'd like to wrap a piece of wood (for mounting equipment) with carpet similar to my XLT's dark slate interior. I've googled, but can only find $100+ carpet pieces. Is there a place to buy a small square footage of matching carpet? Thanks for any input.

I got some of these and found connecting them to the connector (not the wire) worked best. I am hoping this mimics what it looks like if you have the connectors from the factory.

Is this mod documented anywhere? I'm interested in it as well (and will watch this thread), but would like to get a handle on part numbers and how to check if I'll need to run IPMA wires.

Does anyone know the difference between Ambient Lighting System Strategy "Variant 1" and "Variant 2" as listed in @Livnitup 's spreadsheet entry for 7D0-01-03

Overall it worked well for me. It’s really well made! If anything, I’d have liked maybe 6-8” more length on the driver’s footwell leg of the harness to aid routing. Everything else seemed great length-wise. Also a wire tie with an attached Christmas tree (or similar) to fit into the metal...

Hi, all. Another successful installation here. Thanks to @JHForman812 for the awesome harness and support. Also thanks to @Texas2022XLT, @Puffy929 and @b bo for helpful posts. I'll try to add some value here as well. My 2022 XLT did not have connectors (except for the passenger-side rear...

For sites like factory-manuals.com where the manual is "delivered using your car VIN" does that mean if I have an XLT without some as-built feature (e.g., ambient lighting) the PDF I receive would not have references to ambient lighting? I don't quite understand the implications of what that...