Recent content by maxinike

page 29 printed owners manual under data privacy section, and yes you right ford cover their butt

It can be done by OTA and that clear the recall notice

Just keep in mind in case of you involved in an accident and police suspect device to trick the system as been used, they can request the last recording of the camera from ford

Dealer will blame you for the damnage if not reported on delivery Because it cant be claimed on warranty

Good idea for the light itself, but the key will keep waking up the modules and could cause batt drain over time..

It may receive signal from your key. These model catch signal from far away. Do a test to see if caused by the key like taking it far away or store it in a metal box. Had this issue a home and i had to bring the key at the side of the house

The BCM is the body control module. Its the main module that take care of mostly all electrical and electronics in the truck. There is a strategy programmed that if the batterie go below a certain percentage usually around 60-70, some of the accessories or feature not required to keep driving...

you have a low state of charge in BCM and 20 minutes driveway drive won't change the SOC. In this case the batterie may need be charged wit negative terminate on chassis or frequent long trip on highway but more that 20mins drive. Also vehicle need sit at least 8 hrs to update the SOC and resume...

like said before the power supply will charge the batterie but won't change the state of charge in BCM. That is what the process of programming look for before programming a module. You will need a slow charge for several hours(min8 hrs) with negative charger cable connected to vehicle chassis...

For all ecoboost engine built on or before may 12 2022

Look for 22-2224. To reprog pcm and all others powertrain modules if its a powerboost

Tsb is out . Go see your dealer for the update

this bubble has no meaning. software glitch and no fix available at this time

Any slow charger compatible AGM will do the job.

lots of conditions must be met to have auto s/s working like temp, engine temp, seatbelt but the one people are not aware is the state of charge of the batterie . If below 70 % it will stop working cause want save power. Charge your batterie overnight with negative cable on chassis and reset BMS...