Recent content by jstulbaum

I just ordered a set of the Tremor tails w/BLIS and harness to replace my XLT 302a Halogens w/BLIS. I was under the impression I would just use the new BLIS that came with the tremor tails. I know I have to go into forscan to change something due to halogen to led….but is there something I’m...

1FTFW1E84MKD94982 ‘21 XLT 302a FX4 latest update 2.7.4 Oct 15 2022. My auto start/stop recently stopped working so I think I’m draining my battery/not getting a good charge which is not allowing for OTA updates. Only drive it 2 times a week on short trips usually, and it may sit in the garage...

No I stopped waiting for the Eibach coilovers and purchased the Icon Stage 2 package with their 2.5 coilovers and 2.0 rear shocks.

Update….. Turns out the directions that came in the 21 icon stage 2 package indicating max thread adjustment was incorrect which explained why I couldn’t clear the 35s with the painted bumper. Directions indicated the max shown threads should not go over 2” resulting in the max lift (2.75”)...

Ya I’d love to know if we could get the list of part numbers needed to add the tremor skid to ours.

What does your rake look like now. I’m running the icon stage 2 kit on mine. Have it adjusted to about 2 1/8” on 17s. Wish there was a tire ratio for the 17s like you have there with the 295/70/18s…..might try that set up next time w/ 0 offset 5” backspacing to satisfy the icon UCA.

Update: After speaking with Icon the max thread setting on their instructions are incorrect. The max thread showing setting is actually 2.5” to give you lift of 2.75”. They come in the box at 0.8” of threads showing which equates to 1.75” of lift. I’m currently set at 2” of shown threads which...

Had me a little nervous with the full lock rub with the 285/75/17s then I saw yours is 2WD…what motor? And what kind of lift do you have in the front at that point? Wanted pro truck lift way before I bought the truck, and then saw you guys didn’t approve them on your 21s. So then I had your...

Hope this isn’t the case for me in Santa Clarita. Need to update my speedometer.

Sadly I must report they didn’t fit. The 35x12.5 on a 0 offset wouldn’t clear my painted bumper. Icon says not to adjust more than 2” of shown threads above the top cap. My rake currently is a difference of 0.5” so I’m guessing it gave me a 2.5” raise in the front. I’m confirming that with lock...

Hey all! New here but just recently got my 21fx4 3.5 end of October. I have always had the plan to get the eibach pro kit due to tons of trucks I follow all run them (but they weren’t 21s) after not seeing the pro truck kit listed for the 21s I decided to contact eibach. They said the spring...