Recent content by Jbcaindo

Where are you located?

Zero chance nick will remote tune a Mobridge aio.

Plenty of speakers fit the dash without trimming or re-shaping the duct work. Blam lfr-52 is a common one I do if the mid-bass can meet it around 500hz. If I use a midbass that struggles past 350, I'll use a 3" (80mm)

b&o is 100% a different interface. haven't had a non b&o apart yet to see if they are different too.

But it's not informative if you're leaving out key details to save the end user money, time and hassle. There is ZERO need for an LCi product in these trucks. Putting a full range speaker in the lower door of an OEM 2 way system is COUNTER productive and more expensive. Investing money in...

I did. You're in transit shots show an LCI and an amp that's capable of hi-level and low-level. Zero need for the lci. You still don't need full range speakers in your doors. You show 3way JL 6x9s. You still could invest your rear door speaker budget into the front stage or a better amp/dsp...

You don't want full range speakers in the front doors. You don't need a LOC. Use forscan to convert output signal to low level or use the amps hi level ins. Skip the expensive rear door speakers and focus on the front stage and amp. Use the saved money and leave oem rears entirely oem and...

Here's an rta of one of the ci5 8" woofers in the front door. This is NO eq, crossovers set at 35-250 24db LR on ~160w rms. I ended up crossing it at 45hz due to a phase issue with the subs. This should give a SOLID idea what these door woofers are capable of. With another 80-100w rms I'm not...

Final rta on right screen. Before minimal salt and pepper by ear changes. So Scott reached out and gave me an initial budget to which we spec'd a 2way active front rear and single slim 10 behind the seat, with Match amplifiers. The limitations were definitely going to be the single sealed 10...

Not sure what that's about but; the reality is this, once you decide how much you're wanting/willing to spend, self or pro install, expectations and the area of improvement(s) most important to you then and only then can the road map to success be designed, built and executed.

That's a conversation few are ready for :).

There's nothing different from prior years.

Glad you got taken care of quickly and are finally happy with your system.

You'd be surprised how much resonance can be absorbed from the outter door skin. I use resonix guardian on the outters, resonix cld on the inner and door card with some butyl rope if budget allows. If a tight budget, it's guardian on the inner and soundskins on the outter and speaker rings.

What exactly are you trying to accomplish?