Recent content by Doc Boston

Dealt with this on my 2024. Different frequency sensors starting in 2024.

You can leave the heating elements in the seats. You’ll need additional parts and a new HVAC control to enable them, although I’ve heard you can use the infotainment screen too, but you’ll need additional modules to drive the heating elements. You have a 2024 so you will likely have an airbag...

The XL still has a fleet option for 2025 with power driver seat option (option code 91P). What year are your donor truck seats? I doubt they made two different XL harnesses. Also, did you disconnect the controls on each seat if you reupholstered them? Is that all reconnected at the controls? I...

Yet another regular cab short box build. My 2024 5.0 XL. Purchased new from Scarsdale Ford. All parts are Ford or Ford Performance- Factory carpet and mats Lariat heated leather wheel Dual 10-way power seats with lumbar and angle adjust headrests Center seat with accessible lid XLT fabrics...

The fabric, foam and sensor are each separate parts- fabric off first, foam lifts out, sensor affixed to the bottom frame via two black Christmas tree buttons.. I see a typo in my earlier comment- be careful how you route the fluid hose. Take a pic of how it’s installed before you remove it...

The seats built in harness will be fine. Swapping the airbag and sensor are also easy. No need to completely pull everything apart. You can change the airbag by fully opening the zipper on the airbag side of the seat. The bottom foam and cover take a little time but you only need to lift the...

Hi, Yes, a 2024 date airbag and 2024 date occupancy sensor pad fixed the problem. No more airbag light on the dash. They indeed need to be 2024+ to work. The 2021-2023 will not work in a 2024+ truck.

Sold

FS- brand new spare from my 2024 XL 4x4. Zero miles. $100. Located just west of Boston. Thanks for looking.

They are coded differently, from what I can tell. In a week I’ll be removing the 2021 OCS from the seat I just bought and installing a 2024 OCS. There is a versioning error when scanning the truck. I don’t think driving the vehicle will clear the error, the airbag system does a scan at every...

Hi, all, I just installed Ivan's harness today as part of a power passenger seat swap. The harness worked perfectly. My truck is a 2024 RCSB, and the full power / lumbar donor seat came out of a 2021 XLT. The donor seat needed the airbag and fabric replaced, which takes about an hour or so, if...

I ordered it from the dealer. Just use the VIN for a 2023 RC XLT. Get the floor mats too.

2024 RCSB XL here - buy the factory carpet set for the 2023 RC XLT. Direct fit, no issues. When you get that, get the factory cloth mats too. That's what I did. My manual driver seat was swapped with a 10-way power seat from a wrecked 2021 XLT. The seat also has everything in it for a heated...

Just change the bumper bar assembly with one from a tremor. Because you have a 2023, the trailer harness socket and harness will be in the right location. If you had a 2024 non-tremor, they swapped trailer harness socket sides, and the cutouts don't line up in the bumper bar. I think this is why...

I just finished my driver seat swap, and am now exploring the install of a 10-way power passenger seat as well. For those that have done this swap, what did you use as your source of power? Any pin-out diagrams you could share would be appreciated too. Thanks.