If you do, or for anyone else interested, I have seen people paint them on the truck. Don't. Just take them all off, give them a nice clean and make sure they're dry. Do lots of light coats. You can tape off around the tire or use playing cards as some do, but I did not. It's black rubber paint...
Yep it is the ReadyLift 66-2215 2.25" - got it on Amazon. And I have 35x12.5's
I used probably 4-5 cans of regular black (5 wheels including the full size spare). Then hit them all with a couple coats of "Satinizer" plasti-dip. I may do some more satinizer, not sure yet. I went with dip...
As far as the spare fitting, yep that should fit just the same as mine. For the spare rim, I actually went on ebay and just found the same oem rim and ordered it for like half the cost. There are some places selling like-new rims, might be worth checking out. But yes you should be able to...
Tried it today using the 2.3.45 software and made sure to check "auto increase" in the connection tab under settings. It completed the PCM relearn with no issues. I still have code U0131 under the ABS module and IPMA module so I need to figure out what they mean.
For others having issues with the "service procedure interrupted" where it fails to write data or perform the PCM relearn, contact the Forscan team and tell them. They will most likely send you a link to the newest software (2.3.45) which can potentially fix the issue. I have not tried it yet...
Anyone know what I'm doing wrong ?
Converted my 35x12.5R18 tires (34.5" dia) into the following because there is no direct conversion:
Which puts out the following hex code/numbers to change in forscan:
Set BCM line 726-15-01 to the following:
xxxx xxxx 0Axx
Set BCM line 726-15-02 to...