Recent content by belairbrian

Probably FL3Z16A455BA You should be able to verify here. made a couple assumptions on your configuration running board IPB

For those that haven't seen an XL dash

My 22 STX always shows it at the bottom of the screen. For about two weeks I couldn't figure out what the constantly changing fraction was telling me. 1/10, 2/10, 3/10 and so on. Then it hit me what it was.

Interesting question. I can remember many years ago driving across upstate NY in a winter storm. One of those sleet snow freezing rain messes. Drove from Rome to Corning, by the time I got there there was Ice covering the headlights. Only a circle at the center remained open, and that was with...

When I bought my 2022 used, the drivers seat bolster on the back of the seat was torn. After some searching on ebay I found a complete set of my covers for $150. Swapped it out myself and put the extras away for future needs. Since these trucks have airbags in the seat backs, keep that in mind...

OP, buy what you want and don't concern your self with opinions on looks. It's a cap. It can be easily removed if a future buyer doesn't like it. looking at the picture posted by moritzes that step in at the front would be something to investigate might be a leak point. After several $3K plus...

I guess so. I just looked and my sync version is 25094_PRODUCT revision 1779. If that means the recall is done, it was OTA. Haven't been near a dealership in over a year.

I noticed about an inch of water in both tailights. By the time I noticed it had ruined the reflective coating. The truck originally was owned by a small town govrenment. Driven by the mayor. Best guess is they added some lighting, probbaly flashing, then took it out when they sold it Picke...

Wanted to give this a while before I posted about it. Well just past a year with it so I can say overall it's a success. The only issue is when the dash says OAT is over 100F. The thermal protection kicks in until the A/C cools the cab down. I can say it took a dousing with 12oz of coffee and...

I took our MDX into the Acura dealer for a leaking power steering line. Since you have to lift the block off the rear mount, the $400 charge seemed Ok. Then I get a text form the service writer, recommending new wiper blades and a blower motor fan cleaning, $50 and $200 respectively. I told...

I witnessed a similar accident. A truck came flying past me and hit the car so hard the trunk complrly collapsed to the back window. Driver's back was broken in 5 places. Luckily the car seat in the back was empty. When police arrived it wen like this: Q Did you see him driving the truck? A No...

i'm happy with the half safe I put in my 2022 STX. The Tray is 3D printed

Until she realizes you can make her things. When I bought my first it was a "waste" then it was could you make omthing to hold the measuring cups on the cabinet door. Could you make astand for this. I currently have 3. Two active and one put away on the shelf. Just finished a vortex dust...

Cura and Meshmixer also return errors. Cura returns a no mdels found and meshmixer returns just a file error message. Both programs should open a 3mf file

I've had this happen a couple of times. One of the following helped. While navigating: Touch the gray turn box to shrink it then touch again car play should announce the next turn. touch the screen and the volume controls should appear where the speed limit is. There is a mode that only...