Recent content by beaver24

I used the cheaper "example1" harnesses from page 1 above (Starkey #4732) for someone else's truck. Much quicker to modify and cheaper if all you want is turn signals on Raptor headlights. Same wiring logic as the original harnesses I used through the diode pack. I can make a schematic for...

No, but I could help you with them. The easiest route is to buy No, but I could help you with them. Ordering the Starkey harneses then modifying them is the easist route. DM me and we can figure something out.

https://www.ebay.com/itm/405476331822?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=t-orkly3ryk&sssrc=4429486&ssuid=3guDo8zUSPO&var=&widget_ver=artemis&media=COPY

Nice! That's awesome!

Got the fog lights installed. Diodes between turn and drl on those worked too.

Dang, those should be way cheaper! Sorry to hear that. Well, at least you'll have it done here soon. Digikey shows 93 in stock of those #AT04-4P-RT01, if it's not to late to cancel the other order.

That sucks. Did you get the Deutsch male 4pin DT connectors, DT terminals, Molex terminals, TXL wire, etc? Some crimpers as well. If not, DM me. edit: Strange, I see 93 in stock of #AT04-4P-RT01 at Digikey. 14week leadtime is if they are out of stock.

Not at night, but headlights on. Camera refresh rate make it look like it's glitching, but obviously it's not. You can see where the amber goes dim and bright.

@beo_tom Sorry, I forgot to post this schematic the other day. I only show the effected wires, and not the pass-thru wires.

What did you find?

I write schematics for a living. If it helps, I can draw this up in Draftsight tomorrow at work in 20 minutes. It may help others too. My snip-it tool, mouse writing above isn't the best lol.

So you have the same adapter harnesses I have. It was easy to rewire those. Because the way Starkey crimps the turn together on the headlight side and where they splice into the DRL for their 6-pin Deutsch branch; just pull the turn from the oem harness side and then pull the DRL from the...

Verified that turning the front turn LED outage to OFF is still needed.

It dims to what your BCM 726-38-01 is set to. I will record at night, but from the driver's seat and watching the reflection on a car in front of me, it looks like it goes off. But the command is to dim. DRL dim is set to 10% duty cycle. When the turn signal hits, I'm not totally sure if the...

In the end, for my Lariat, I think I only needed to change: *726-38-02 xx01-xxxx-xxxx to set the DRL to dim with turn. *Then ensure your DRL brightness for dim setting is at the factory 10%; 726-38-01 xxxx-0Axx-xxxx. *Then doing the diode rewire of turn signal into DRL as mentioned above. I'm...