Recent content by Beatrocker248

Have a few questions (wanting to add a Pos. & Neg. 2 AWG wire towards the rear of the cabin for a distro block): How far deep does the 1st and 2nd layer go? The grommet you drilled is behind the grommet with the plastic trim heading inside the cabin for the blower right, right by the passenger...

Nice! Any pics you can share? Did you add any fuses at the end of the wiring harness or would be a later addition depending what your trying to connect to? Which Auxbeam in particular did you add? Already came pre-fused? For now I have 4 upfitter switches available, 2 are going for the KC...

Yes! Something like this is what I was thinking of. Was also thinking of placing the block at the rear of bed for easy access and not having to drill holes from the small ports on the front side of the bed where usually the drain tubes go when you add a tonneau cover. Thats why was thinking of...

Hey Everyone Just like the title says, was wondering if anyone has added a Power Distribution Block on the bed side? Want to do several add-ons (KC Gravity Titan on sports bar, ARB Compressor, exterior lighting, etc.) and instead of making each individual harness extend all the way from the...

Gauging Interest I've been able to add the functionality that of the Raptor 3rd Brake light with its Running Lights onto a Morimoto XB3 without having to remove the unit at all and connecting through the passenger footwell. My idea is that I would like it to be as Plug & Play as possible with...

Reviving this thread, any luck in what changes were made to Forscan?

Would you happen to have a list for the extra fuses you had to buy plus the wire connectors and pins you used and a diagram of how you wired them? I'm about to start on mine but since I don't have the power rear window nor the air refresher, it'll just be the regular overhead console with the...