Recent content by Bdubbs1198

I have front and rear and ran a power wire from front to back. Would be cool if there was an OBD module that would record to micro SD card.

Don't worry about SOX, your voltage is good. Mine was low too when I started because everyone's batteries suck, lol

That's weird, I'm already at the apim. I guess it's because it did it via USB after my subscription expired and hasn't reported back to mothership

@Snakebitten can you do me a favor and check me? I know inhave a TCU update but don't want to spend another 50 if it's just that for now. 1FTFW1ED2MFB98397

I like that display. Not TorquePro, which app is that?

I had the USB 0 error and tried to go through the TSB process. While doing the recovery process it wouldn't connect with the USB cable i was using so I had to cancel. After I hit cancel I quickly looked to see what software I was at and it was no longer blank, pre 1.7.1. So I immediately...

Lol

Yes. It burned the engine compartment, the dash, and the sheet of plywood in the bed caught fire, lol. I've never been to a car fire that isn't totalled by the time thr fire, smoke, and water damaged everything. Unless you stop it right away, it's going to be totalled.

All manufacturers have fires. I put out a fire the other day in a brand new Chevy 2500. The guy said he saw smoke trailing him, pulled over and grabbed stuff out if the cab before it became involved. It looked like the fire started back at the transmission, so likely a transmission line that...

There is an IPC update that might address this issue. Not sure.

Yes, you can walk away during the download but make sure you have a charger hooked up with 10amps and the laptop is charged. I would check in every 15 minutes or so for the APIM downloads. Some were faster than others.

There are some that are multi linked. i cant recall which ines, but it does warn you. It says that the update affects multiple modules or something like that. The APIMs are the longest. I probably spent like 10+ hours updating from 1.7.1 to 3.5.3. The TCU update will bring me to 3.5.4 but...

Yes, mine always said i was up to date, but I wasn't. I spent hours getting myself updated with fdrs

So I think I'm finally at 3.5.3 as the USB kicked off this morning and updated successfully. I'm bow at 22228 REV 539 for a non BC Powerboost Lariat 501a. Maybe it's not new but I do like the new navigation on the IPC showing the distance to turn, and no not talking about the little text...

No via FDRS