Sponsored
antho's latest activity
-
antho replied to the thread 2021+ F-150 FORScan List / Database / Spreadsheet.I’m not following. Do you have a work surface? What pin are you needing? There is no pin 2. It’s either pin 1 that’s the signal wire and... -
antho replied to the thread Talked to dealer about a transmission fluid change with and without filter change.I personally would only have what Ford recommends.
-
-
antho replied to the thread Spacer/puck on top of Eibach Coilover.Adjusting the Coilover height shouldn’t cause a stiffer ride. You’re just adjusting the length.
-
antho replied to the thread Spacer/puck on top of Eibach Coilover.Are you topping out or bottoming out the shock?
-
antho replied to the thread Oil Catch Can on V6 3.5 Ecoboost.@MaxMaster1 You referring to the crankcase pressure sensor?
-
antho reacted to TN_Ryan's post in the thread Power Tailgate on a RCSB?...Yes Please! My DIY Install with
Like.
During the course of adding all of the personal touches to my truck, I paused at the power tailgate mod since it seemed the general... -
antho replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Can you post your SCCM asbuilt?
-
antho replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.https://www.rapidtables.com/convert/number/ascii-to-hex.html You can put your vin in here and convert it. You just have to make sure you...
-
antho replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.This is the VIN that is currently in that HCM 1FTFW5L80SKD28128
-
antho replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.so block 12 is the VIN in HEX.
-
-
antho replied to the thread Glare free not working: 302a XLT upgraded to Projectors w/ HCM.Did you put your VIN in the HCM asbuilt? Also may have to run the TRON auth in FDRS.
-
antho reacted to jkosh22's post in the thread 10r80 Transmission 100,000 Mile Service Performed (filter & fluid pics) with Like.
For anyone who is curious, I’m sure there are a high number of trucks approaching 100,000 miles. Which is a perfect time to do a filter...
-
antho reacted to FirstFord's post in the thread Changing 10R80 Fluid cold? Is it possible? with Like.
NICE garage and lift setup! Bringing the trans up to Ford's recommended temperature for a fluid level check can be a challenge, and...
-
antho replied to the thread 2021+ F-150 FORScan List / Database / Spreadsheet.@ZKeith Did you look at the first post? It has the link to the Forscan sheet. BCM 726-46-01 xxxx 01xx xx-- BCM 726-50-02...
