Recent content by Andyc

Not keen on the plastic caps that come with the methods. Used plastic tube caps and had silicon graphics made up to go with the bronze and Velocity blue of thetruck. Got a matching steering wheel silicon made.

Have 30mm spacers and studs protrude slightly. Inside face of the 2021 18" sport wheels are not flat on inside mating surface ( probably to reduce risk of sticking between surfaces). These indents are enough to clear studs without any problems. Aftermarket wheels may be different.

This is who I got it from on AliExpress. 7 choices. Should cost you less in$ as we have to pay 20% VAT in UK.

The 1 minute modification. 100% plug and play puddle light. If you get bored with it, 1 min and you are back to OEM.

Ebay $65 back in August. Just checked and a couple on there from $85 plus postage.

Interesting to see you say they are the same as rear. I know they are the same physical shape, but the rears come as a number of different part numbers and prefix letters. Do you know if they are all the same internally and would work being swapped front to back. Or would they not be recognised...

If you follow thread earlier. List a supplier on eBay. Also available from AliExpress.

Since posting the above pin out. I have acquired the 700+ page wiring Bible for the 2021. This may help more. On my sketch the pin numbering is different to that below. Using below the turn signal is No 2 for both LH and RH.

Rocky Ridge have them on some of their trucks. Doubtful they are available as separate item.

Added some color pedals to the footwell and carbon fiber pattern covers on the roof horns.

Which did you connect to for live feed. 3. Violet/white ?

Your wiring appears much the same as mine, as it should be being same the same model. Having not had any response from asking the same information on a few forums. Ended up pinning out what I could. Left hand headlamp female connector. . 1. Blue (large) 12v switched on low beam and high...

Update: Slightly more involved as have to remove the 4 white plastic clips that attach the bottom valance to the front, once these have been removed the full front plastic part can be unclipped by pulling forward together with center section. The center plastic will then unclip and can be r...

Attempting to top up blinker fluid.