Hey Kev,
It's been a while but I'm here to reply.
I eventually created my own wiring harness to splice in between the original wiring harness, to a load resistor for the LED turn signals, and installed a connector on the turn signal wiring to mate everything together. This allowed me to remove...
Around 3-4 months ago I had upgraded my halogen bulbs to LED including my turn signals. I had done this mod before on other trucks and vehicles and the process is the same... splice in a led load resistor to prevent hyper flash, install the new bulb, and done. However, after a few months after...
I'm in the middle of this now...
I have an XL STX that doesn't have the extra upfitter switches but I'm wondering if the wiring is there even though it doesn't have the extra switches installed from Ford. I know in the past Ford has left wiring and harnesses in trucks from the factory that don't...
Heads up for anyone with an XL or STX trying to do this...
Apparently on higher trims, the driver's rear seat is supposed to ride up when you pull up the seat bottom, in a dual-action motion... XL or STX trims do not. I installed one of these seat releases and there is a black molded piece of...
Hesitant to take to the dealer, truck shifts like it originally did... I'm able to feel every downshift coming to a stop. I read on here that they'll just reflash the transmission, but couldn't I just disconnect the battery for 10-15 minutes and let it re-boot the transmission learning cycle...
Just had this happen to me today...
I was driving at normal speeds and shifting normally, out of nowhere (around 4th or 5th gear) loud clunk and clatter from the transmission. 'Service Soon' and check engine came on. I pulled off and checked for anything spilling out of the transmission but...